February 2, 2023
Description
This pull relief is made for 6 mm cables (antenna cable in my case).
Print it with 0.1 mm layer height and everything should work fine.
bruncedric relesed thing:5262888, which is very similar. His "cable screw conector" is for a greater variety of cables. Check it out!
I needed it a lot smaller and as bruncedric didn´t allow derivates, I had to draw everything from scratch. I will use two of mine to build an 1800 Mhz-LTE-Antenna.
Use Freecad to modify/remix it.
License:
Creative Commons - Attribution - Non-Commercial
willie42
