Cyberpunk GUTS Shotgun

This is Rebecca's shotgun GUTS from Cyberpunk Edgerunners, also appearing in Cyberpunk 2077. It is a variant of the Budget Arms Carnage, a cheap pump action shotgun. GUTS variant holds a greater number of more powerful shells then the standard issue version. GUTS was a personal weapon of Rebecca, and was added to the game after the release of Cyberpunk Edgerunners.

You will need one each of parts A thru H. If you want to use your own supports, choose the files that do not have the word "supported" in them. However if you would like to use the tree supports that I used to print the file, print every file that has "supported" in it. Parts D and F do not need supports at all, so be sure to print those as well if you choose to print the Supported files.

The supports in the supported files should break away cleanly with no issue. Use side cutters to break them in the middle, and then either pop them off the part with a knife or clip them with your side cutters. they should come off cleanly in large chunks with minimal to no damage to the part itself.

The sling links that print vertically tend to be pretty fragile, you will likely crack one when you remove the supports. a dab of superglue on the crack resolves this quickly and easily.

I HIGHLY suggest you print with a brim, i used 6 mm brims and this helps the supports stay connected to the bed, and prevents any warping. a raft would do the same but a brim is better suited here. You can get away with 5 percent infill if you use enough perimeters, i used 6 perimeters and the part is very sturdy.

Additionally, it appears the parts are rotated differently then I have them saved. Just make sure you rotate them appropriately in your slicer.

UPDATE:

I have included a set of display hooks for the print. Refer to the photo of my completed print for placement. These I suggest printing on the side, so they come out stronger. I used 20 percent infill but you can probably get away with less if you use more shells.