Starmaker2-3

This design was an experiment that did not turn out so well for me, but I decided to post it anyway in case someone wanted to see if their printer could do better. The problem is shown in the 4th photo - the slope of the geometry near the bottom is too low and the layers didn't print properly.

This may be due to me using a 0.200 mm layer height - but I did specify a variable layer height with the hope that Superslicer would calculate good intermediate layer height values. It might have been better of I had just set layer height to 0.100 or something like that.

This design is similar to https://www.thingiverse.com/thing:5950904, but because it is smaller I switched to a 3-sided squircle, and I also added pointy tops to each of the arms. The print completed in 5.5 hours using a print speed of 100 mm/sec.