lego technic sg90 1x3 Servo Adapter

NOTE!: the SG90 actually has 21 teeth, while my design features only 20. As shown in the picture, my print was successful and it has a good fit, so I didn't notice the mismatch. BUT IT DOES NOT FIT EVERYONE! Perhaps I just got a lucky print :)

This is a LEGO technic adapter for the sg90 servo motor.

With this, you can integrate your servo motor in your own LEGO build.

IMPORTANT: the servo motors sg90 and mg90s have diffrent hole sizes! I have booth sizes in my profile.

Dimensions:
1 x 3 x 1 Lego pins

There are 2 lego compatible holes and one hole for the sg90 from the top.

The hole openings from underneath are rounded to get better print results.