Magnetic Fidget Slider V3

This is my third version of my fidget slider. I started learning Autodesk Inventor and wanted to put what I learned so far to the test. The problem with V2 was that the sliders were jumping out of the base if you'd slide more than one at once. So I made a groove to keep the sliders from jumping out.

For the base, you'll need five 8x3mm round neodymium magnets plus one for however many sliders you'd like to have (personally, I like to have 3)

Magnets should fit right into the holes and stay there without help. If yours happen to be too big, use a bit of ca glue, if too small check your bed leveling as this might happen if the elephant's foot is too big.

Insert the sliders from one side with the wider opening. You should be able to put them in or out without any problems.