Lynx-90

This is a body kit for the Orion Blaster Lynx - https://orionblasters.com/
Inspired by the P90 it has magazine storage at the front to maintain the aesthetic.

I probably wouldn't recommend this for your first Lynx build since the intent in this kit was to just swap over parts from an existing Lynx
This pretty much just replaces the Rail 1&2, Receiver, Grip, Trigger Guard, Spacer and Stock.

The trigger guard is in two pieces and ideally should be glued together, along with two of the Trigger Guard Peg.

The release is intended to insert into the square hole in the existing mag release. Once assembled it should stay in (or at least not fall out) but otherwise you could always glue it in. You will likely need to pull the stock apart a touch to be able to get the magwell in but once in is quite securely inside.

Overall this took the better chunk of a 1kg spool of filament, but as usual ymmv depending on wall count, infill, etc. Should be able to print without supports, although Front 2 is really dependent on bed adhesion - even with a whole lot of brims and brim support I had a lot of trouble with getting it to print properly until I changed from a glass bed to PEI.

As per the original this is under CC-SA-NC license. I had nothing to do with the original model, this is purely because someone taught me CAD and now I'm making it everyone else's problem.

I have absolutely no commercial interest in this. If you already have a commercial agreement in place with Orion Blasters, and for some reason someone actually commissions this from you, go right ahead, don't worry about getting in touch with me.