Wine bottle holder with tree support

Yesterday I printed the model, but with a bottle as the main model to break it out. Since my generated tree support almost broke in the process, I designed this model to put a bottle in.
Model V1 has a wider bottle neck than V2.
I think V2 fits a little better at the neck of the bottle, but you can also adjust the neck to a bottle later by heating it with a hairdryer if you want to.

You need a slicer for the model that generates a tree support. I used Bambu Studio.
Here I had to construct something on the ground so that the part of the bottle stays in the air.

I have created V3 but I tried to pull the model from the support.
Next time I will keep it in place.
I had also sometimes a slightly different tree support again by simply repositioning the model or the angle of the model to the build plate.

I love this model. I hope you do too ;)

Here is my Instagram post for this model:
https://www.instagram.com/p/Cs4A_7sNH57/?igshid=MzRlODBiNWFlZA==