VENTOLA ACCHIAPPAZANZARE E INSETTI - MOSQUITO TRAP

MOSQUITO TRAP IS AN ALL NEW PROJECT SUITABLE FOR THE SUMMER PERIOD. ITS OPERATING SYSTEM CONSISTS IN ATTRACTING MOSQUITOES AND FLIES AND VARIOUS INSECTS THROUGH ITS POWERFUL UV LIGHT AND THROUGH THE FAN TO SUCK THESE IN AND TRAP THEM. THE ENTIRE PROJECT HAS BEEN STUDIED SO THAT IT IS PRINTED WITHOUT THE AID OF SUPPORTS (WE RECOMMEND FOLLOWING THE INFORMATION GIVEN ON EACH MODEL TO ROTATE THEM EFFECTIVELY). REQUIRED COMPONENTS :

-5MM 20mA UV BULBS

-FAN 120 X120X 25 mm

-RESISTORS 470 Ohm

-DC 12 V POWER SUPPLY CONNECTOR

-HEAT-SHRINKABLE SLEEVE

-12V POWER SUPPLY

-12V SWITCH

-4 SCREWS M4 X 70 WITH RELATIVE M4 NUTS

-MOSQUITO NET

-SUPER ATTACKS

-MAGNETS

PRINT ALL THE PIECES (layer thickness 0.2 mm, filling 10%, speed 60 mm/s, with my ender 3 pro about 8 hours of printing for each piece, total weight of printed components 200g, pla silk bronze and pla blue fluo), THEN GET SUPPLIED WITH ALL THE MATERIALS GIVEN ABOVE, THEN INSERT ALL THE UV BULBS AND CONNECT THEM IN PARALLEL FOLLOWING THE DIAGRAM EACH BULB ONE RESISTOR AND THEN CONNECT THE FAN, POWER SUPPLY AND SWITCH. THEN GLUE THE 4 NUTS INSIDE THE CYLINDERS (see figure), WITH SUPERATTACK AND ALSO GLUE THE MESH AND THE MAGNETS (magnetic closure for cleaning) AND THE UPPER COVER PIECE AND CLOSE ALL WITH THE 4 M4 X 70 mm SCREWS . THEN SUPPLY POWER THROUGH THE 12V POWER SUPPLY AND ENJOY THE TRANQUILITY WITHOUT INSECTS BUZZING AROUND.