Genie Garage Door Opener Holder Mounts (3 Types)

by Segasonicfan Designs
https://segasonicfan.wixsite.com/retro
@SegasonicfanDesigns on youtube:
https://www.youtube.com/@SegasonicfanDesigns

--

Losing the garage remote sucks. so never let it happen again! :P
These use very small unobtrusive M2 wood screws. Easy to tap into drywall and cover up later for the landlord :P

There are 3 types here:
a) vertical wall holder for large remote
b) vertical wall holder for small remote
c) horizontal holder for small remote (good for under shelf / cabinet)

*Best to dial in Cura expand settings for dimensional accuracy. But may print OK without that (not a super snug fit).

Adhesion type: skirt
Supports: no
Bed type: PEI
0.4 nozzle, 0.2mm layer height, 20% - 40% infill
PLA (any brand but I used Polymaker)
Nozzle 205 C
Bed: 65 C
Speed 30 - 50 mm/s (I always set first layer to ultra slow 10mm/s).

I printed with Ender 3 S1 Pro and Cura slicer. It likes these settings:
Retraction: 1.6mm
Retraction speed: 40mm/s

Happy printing! Leave comments or likes or post your makes!
-Segasonicfan