Yeti 30oz Handle with Magnetic Counter

This remix adds in a magnetic counter for the 30oz Yeti handle. There are 3 hollow cavities inside of the handle which you'll need to have the print pause before they are covered to insert 2X 2x5mm magnets into each slot. Magnets need to be aligned so that both faces are the same pole. You might need to glue the first magnets in and then the second on top or else they will try to pop out from polar repulsions. I used a little bit of filament to hold them in place while super glue dried. After you're print is done, another 3X 2x5mm magnets can be used as the counters. They should slide up and down between the embedded magnets.

Now you can keep track of how many cups of water you've gone through!