Fuwamoco Twins Choker

Bau Bau!
“Not Tommorrow, Toady!!!” - Mococo

I recently watched the debut and opening weeks of the new Hololive English's Generation Advent and really wanted to make the choker the Fuwamoco Twins wear!

This model might seem difficult to print but with specific orientations and brims it should print with minimal or no supports!

Main Crystal: This part has what looks like steep overhangs and bridges but printed with a brim with 40 rings I found no need for supports and the model stayed on the build plate. If the model does not stay additional supports can be added but might hinder quality as did in my case.

Chain: This model is meant to be printed at a 45 degree angle! I recommend adding a brim to ensure the model stays on the bed, supports are optional.

Necklace Connector: Please print this piece with no supports to allow for easy addition of the chain. I found that I did not need to stop my printer mid print as the gap between sides was enough to pass a chain link through!

P.S. The spikes can be printed or omitted. I normally dislike printing smaller parts because they often break off the bed or look bad but I felt the design lacked something without them!

P.P.S. I used a small line of trim I had lying around for the choker band, you could attach it to an actual dog collar if you are doing a full cosplay.

If you want to know more about the design process I will be posting a video to my YouTube channel after all my most recent files are finished. Link here: https://youtube.com/@aceganghub

If you have any suggestions please leave a comment or post your make!

Fuwamoco Twins: https://www.youtube.com/@FUWAMOCOch