Peon230 - Quadcopter

Designed for strength, function and light weight, build yourself this 230 size Quadcopter frame.

All parts printed at 0.2mm layer height and 3 perimeters.

-Top and Bottom frames, HDcam and FPVcam @ 30% infill x 1 of each
-Arms @ 100% infill x 4
-ArmSupport @ 100% infill x 2

http://youtu.be/-e-3kbXzwzk
http://youtu.be/jaZK9bDb17U
http://youtu.be/BU2Z-EG56js

Suggested Setup:
-Motor: RacerStar 1806 2280kv or Racerstar 2204 2300KV
-ESC: Racerstar RS20Ax4 20A 4 in 1 (inbuilt PDB)
-Prop: 10 Pairs GEPRC 5040 V2 5 Inch 3 Blade Propeller

-Flight Controller: F3 Acro or F4 with Current Sensor

-Battery: ZOP 3S 1100mah 65c or ZOP 4S 1100mah 65c
-LiPo Battery Charger:
iMAX B6 Digital RC Lipo Balance Charger
12V 5A AC Power Adapter
XT60 Connector to Banana Plug

-Remote Control:
FlySky FS-i6 or
FrSky Taranis Transmitter and FrSky XM+ Receiver

HDcam mounting strap slots compatible with Mobius, RunCam and GoPro.

-Optional extras if you need them:
Lipo Battery Tie Down Strap
XT60 Male Female Plug Connector 12AWG 10cm Power Cable
Silicone Anti-vibration Pad in for 22XX Series Motor

Non-printed parts required:
-12 x M3x10mm countersunk screws for Top/Bottom frame (Amazon affiliate link)
-6 x M3x40mm Nylon Spacers for Top/Bottom frame (Amazon affiliate link)
-8 x M3x12mm countersunk screws for Arms (Amazon affiliate link)
-8 x M3 Nyloc nuts for Arms (Amazon affiliate link)
-3 x Vibration Ball Dampeners for HDcam

Updated
Base and Top v1.1 - rear mounting spacers moved further back for better rear arm support.
Added 22 size Motor Arm

Enjoy this design? Consider supporting me on Patreon: https://www.patreon.com/Tech2C