My wire rack shelf crimper pliers hanger

My wire rack shelf crimper pliers hanger

I have a few of these crimper pliers now. I keep my stuff on a wire shelf and they fall off and fall through the shelf sometimes so I designed these hangers.

The front top wire is 5.5 mm’s diameter and the rest of the wires are 3.0 mm’s diameter.
The gap between the front wire and the next wire is 29.5 mm’s apart
The gap between the following wires is 31.6 mm’s apart

Both of these measurements are an average as the wires seem to flex a little bit.

The center pocket for the pliers to hang down measures 20 X 52 mm’s

I made 2 versions. One for the front pocket that has a 3mm and a 6mm slot for the wire and another version with both slots at 3mm’s for the rest of the pockets. I can fit 2 of these side by side into a square wire pocket.

Installation tip: snap the 3mm side in first then swing it around to the 6mm side.

My shelves are black and I used black filament so it looks great but it doesn’t photograph very well.

They print very flat upside down, a very easy print.

Printed in ABS .2 layer 25% infill