December 13, 2023
Description
Count down the days until Christmas with this rotatable ornament! No AMS, multi-material, or support material needed, only a few layer-based filament swaps and a little post-print superglue.
Print Files and Settings
Two sets of files are included: One set with normal tolerances and one set with loose tolerances depending on your printer calibration. STEP files are also included for both sets if you wish to remix the design!
Print with any material at 0.2mm layer height and 20% infill. No supports necessary. Filament swap layer heights are as follows.
Assembly
To assemble, follow the assembly guide PDF in the file section.
License:
Creative Commons - Attribution - Non-Commercial
caelf
