Vape Cartridge Consolidator (Zelda Edition)

Basically put a mostly used vape tank in the bottom and the top, leave it sit awhile and voila you now have 1 empty tank and 1 slightly more full tank.

highly recommend not painting the tank holder. You'll need to rinse it out with hot water every now and then to get the lil bit of juice that gets stuck inside.

Included "plug"- in Microsoft 3D builder you can use this on objects to create the hole needed to make anything a stand for the cartridge holder to fit into.

The cartridge holder had a hard time printing correctly. Id advise printing as the pic shows (basically upside down).

(My base has a few defects from "production errors" my fault not the file (I think, printed this over a year ago this was designed for a vape tank with an outside diameter of 10.5mm)