BambuLab X1/X1C/P1S Lid Riser w/ AirVent and LED Slot

Inspired by multiple great airvent riser @ printables! no trace or remix but just renew the design from scratch to be simpler and easy to print, just with PLA. No support, No bad overhang to avoid printing failure, No complicated joint or any wasting time cosmetic parts which makes your maintenance cost much higher and easir degrading, mechanical stressess for longivity.

The picture shows additional full width tool box on the front top of printer fits perfectly!
Also this designs carried stuckable feature from references, so you can trace my design to make the optional your own stucks.

w/o LED Install
You can print 4 parts Front-Back-Right-Left first then print 3 flaps and snap them on the airvent panels, finally just put the riser on your printer.
If you just want to fix it harder, can glue 4 parts.

w/ LED Install
10mm double sided tape attached LED tape fits as you go!
(I actually install 10mm width USB powered LED tape with heat-resistant double sided tape point by point)
Glue or temp fixing with adhesive tape 4 parts Front-Back-Right-Left then install LED.
It will be 45 degree angle and it has space for turning so no worry about jummed tape or winding tape issue. Dont forget to print 3 flaps and snap them on the airvent panel.