Losi XXT A-3076 2.61 :1 Diff Gear

This gear is a direct replacement for the 2.61 :1 case on the XXT. The dimensions are tweaked for FDM Printers printing the long side down. A-3076

Just note that it's required to use clear silicone grease to prevent destroying the differential. Ball diffs in these old cars create an excessive amount of heat. You definitely want the diff to be tight enough that when you hold the two output ends you should not be able to rotate the gear itself. Check after a few runs and tighten again.

Horizontal expansion is required for an accurate print. Please note that the part itself already has its own supports. Print without supports.