Blade 130 S Canopy remix for vase mode printing

The original model is very difficult to print. Due to the support, it is slow and uses a lot of material.
I just added it so that it is possible to print in vase (spiralize) mode. This way, you can print much faster, prettier, more economical and simpler, with a single wall thickness. The thickness of the wall can be adjusted by adjusting the diameter of the nozzle, but the 0.4 mm nozzle was suitable for me.

I printed from PLA, it is fragile. You can't cut it around with scissors, because it will crack, so I cut it out with a 180°C, thin-tipped soldering iron.

Unfortunately, the original model does not fit the Blade130S perfectly. The upper opening will have to be expanded a little to accommodate the control rods.
It will probably get damaged soon, but it's still better than buying an original for $15 when it can be printed from 10 grams of PLA in a couple of hours.

Layer resolution 0.2mm
Nozzle: 0.4mm
Material: PLA

Cura 3.6: Special Modes > Spiralize outer contours ON
Slic3r: Settings > Print settings > Layers and Perimeters > Spiral vase ON