Voron 0 Purge Bucket v0 - poop & smack

This is a purge bucket I did for my V0.2 LDO.
It'll make a poop then smack it with the toolhead into the bucket.
Snap the clip holder inside the left aluminum extrusion (near the acrylic) about 20mm from the top aluminum extrusion.
Hang the bucket there.

Add the Gcode.txt code inside your printer's config.

Use the POOP macro in your slicer after PRINT_START line. ( Don't forget to remove older purge line codes).

This was not my idea but I adapted to a more friendly print.