Info:

• Conversion parts needed to turn a Cabela's Top Shot Elite into a modern Lightgun!!
• I recently got a Top shot elite & frigging love it!! So I started looking for 3d models for it, I assembled/edited/created the best parts I could. Hope you find them useful.
• I use and design around P.I.G.S, but should work with any dfrobot camera based system.

Latest Updates 9/26/25(I know months later lol)

• Updating & testing better rail adapter, to cover orange better & use less plastic.
• Updating & testing battery cover to use a GX16 & remove motor spot.
• Working on more sights to use on stock rail.

Updates 2/18/25

• Added sight to rail.
• Aded 4x8mm magnet spots to hold rails together
• Updated camers mount .
• Everything has fit fine thus far.

Updates 10/17/24

• New sights work fine .
• Rumble mount getting adjusted today .
• Solenoid Mount updated . Uploading today.
• Camera mount works fine . Adjusting a little but it's fine.
• Picatinny rail en route to me to test .

Updates 10/4/24

• Sights are so easy just slide on their rail.
• Ordered rest of parts to assemble and film now .
• Greatly improved camera & lens mount.
• Added motor mount thats also a cord guide and battery cover.

Features:

• Battery Cover now one piece with motor mount and cord guide.
• Camera mount has a deeper spot for lens & is 2 part system.
• Added new sight system. Examples Iron-Sight.stl & Circle-Sight.stl
• Picatinny Rail Adapters.
• Solenoid & Rumble Motor Mounts

Parts

Solenoid Mount

• Solenoid
• Plate for extra clickyness.

Motor Mount

• Motor

Credits:

• Camera/Lens Mount modified from Hexxed's "Top Shot Elite Camera and Lens Mount"
• Motor Mount/Cover modified from ThatOneSeong's "DoorCover-PartBody
• Plug modified from Adamperry62's "Cabela's Top Shot Wii Rifle Stock"
• Triangle and Square Buttons . Laserbot's Buttons
• Stock taken from (soon to be remixed ) Kingtut's Replacement Stock

Install instructions:

Motor Mount

• Pull apart gun.
• Lay LEFT side down on table
• Remove everything from LEFT side of gun where battery goes.
• Repeat for right side .
• Remove battery cover
• Slide printed piece in hole/area you made.
• Glue motor in place
• Slide cords thru guide.
• Wire Solenoid

Solenoid Mount

• Open up gun.
• Lay LEFT side on table.
• Locate two pegs in center of gun. They have a weight and nothing on them.
• Glue solenoid in Mount
• Glue plate in mount.
• Slide Mount over two pegs.
• Wire solenoid

Camera mount

• Open up gun
• Lay LEFT side on table
• Remove stock camera and cover.
• Test fit Part1
• Glue Camera-Mount-Part1 in gun.
• Grab camera and Part2
• Screw part2 on camera.
• Screw on lens if you want
• Feed camera wires in to Part1
• Slide assembled Camera into part 1
• If everything works back out and some glue & slide back in. Try not ot get glue on lens or threads.
• Use tape or similiar to hold while glue dries.

Installation Video

• COMING SOON.

Side notes:

• Wanna make your own sight? Use Blank-Sight.stl and add whatever.