Designed to fit 10 x 2 magnets which can be found on Amazon.
🖨️ Print Settings/Instructions:
Print at 100% infill with a layer height of 0.1mm with a base layer of 0.2mm.
Print Gardevoir_Red.stl using Red. This should snap on but if not, you might have to make them a bit smaller and glue them in. Note: These parts are extremely small so care needs to be taken when removing from the build plate to ensure they don't fly off everywhere.
🌈 Color Changes (Gardevoir.stl): - Start with White - At layer #30 (3.10 mm), change to Green. - At layer #35 (3.60 mm), change to Black for the rest.
SuSh11
