Bigbig Won Dual controllers stand

After creating my dual controller stand, I acquired a Bigbig Won Armor-X extension for my Xbox Series controller.

As the support was not suitable to accommodate the controller equipped with its extension, I undertook to modify it so that it could accommodate it.

Here you will find my simple dual controller support: https://www.thingiverse.com/thing:6673552

For more stability I created 4 locations underneath that can accommodate non-slip pads.
For my part, these are standard 8mm diameter skates that can be found at LIDL.
Finally, still for the sake of stability, the part is printed with an infill density of 15% apart from the base which is filled to 80% in order to lower the center of gravity.

I printed mine in PETG but this won't be a problem with any other material.