1200W/1800W DC-DC Boost Converter Module Case

This is a protective case to suit the commonly available “1200W" 20A DC Boost (step-up) Power Supply Modules (8-60V input, 12-83V output - example). It should also fit the “1800W” variant, but this is unconfirmed.

This is being used to supply a Starlink Gen3 router and dishy with 57V running from a 12V source.

I printed this in PETG (as it was what I had on hand at the time). Should not require supports (I printed as is).

Fixings:

1. 4 of M3 x 12mm Socket Head Cap Screws
2. 4 of M3 Nuts

The nuts should fit in the slots in the bottom section of the case. It can be a little awkward to get them in the correct orientation. They are a relatively close fit.

** (20/08/2024) Added 36mm deep version for those with higher power units with toroids up to 35mm tall **