Gyroid fidget desk toy

There are two versions: a hand-held fidget toy and a motorized desk toy.
The hand-held toy is 100% 3d-printed and slots in and out of the motorized base with ease.

Check it out at https://www.youtube.com/shorts/WkCqcTuz9W0

There are different versions of the inner-most axle. There is a minion (https://www.thingiverse.com/thing:403110), a humming bird (https://www.thingiverse.com/thing:3307572), or a blank axle. Using the blank axle, you can put any model you wish inside! Note that if the minion and bird models I used print poorly, it is because I needed to scale them down a lot.

For the handheld version, you need to print 4 'color1-clip's and 1 of everything else (without base in the title). For the motorized version, you will also need to print 2 'base-arm's, 1 'base', and 1 'base-Spur gear'. You will also need a battery holder (https://www.amazon.com/dp/B0CSFFDN56?ref=ppx_yo2ov_dt_b_fed_asin_title), batteries, a motor (https://www.amazon.com/dp/B00GYRSDSE?ref=ppx_yo2ov_dt_b_fed_asin_title), and solder and a soldering iron. The colored PLA I used came from this pack

Some parts may need to be sanded to run smoothly.