Comgrow/Sovol SH02 Dryer Filament Guide Fix

This is a fix to the sharp angle in the Comgrow/Sovol SH02 Filament Dryer Box. The factory guide would cause excess bends and jams causing failed prints unable to pull form the box. This puts it more of a vertical instead of a parallel feed function eliminating the strain.

Uses the factory screw, nut, and rubber seal to maintain air tight.

Print with high temp filament such as ABS/ASA because the inside does get up to 70C. PETG/PLA+ might be OK. No guarantee.

Can insert a PTFE tube on both sides or not. The inside hole is beveled so no sharp edges.

No supports needed! Print with the threads facing up!