Tripod-Mounted Wig Head Holder

This is a wig head holder designed to attach to a tripod with a standard 1/4"-20 threaded insert. This can be used as a single tier (4-head holder) or two-tier (8-head holder). It's possible to stack tiers endlessly, but a normal tripod will likely not be able to handle the weight after two or three tiers.

The tier base parts have rods that allow a wig head with a hole in the base with a diameter of about 1 inch to be mounted to them.

hardware needed:

1/4"-20 set screws 7/8" long
https://www.amazon.com/dp/B019HT99A6?ref=cm_sw_r_apan_dp_E582G8745PAJS79AQ1N7&ref_=cm_sw_r_apan_dp_E582G8745PAJS79AQ1N7&social_share=cm_sw_r_apan_dp_E582G8745PAJS79AQ1N7&starsLeft=1&skipTwisterOG=1

1/4"-20 threaded brass inserts
https://www.amazon.com/dp/B09MTS6ZZQ?ref=cm_sw_r_apan_dp_DAXEZNQ5YA53FYZVEEPE&ref_=cm_sw_r_apan_dp_DAXEZNQ5YA53FYZVEEPE&social_share=cm_sw_r_apan_dp_DAXEZNQ5YA53FYZVEEPE&starsLeft=1&skipTwisterOG=1&th=1

Use a soldering iron or similar tool to heat brass inserts and melt them into the holes on each piece. All holes were sized to accept 1/4"-20 inserts with a max outer diameter of 8.7mm.

1/4"-20 set screws are only necessary to attach the connecting rods between tiers. They are not necessary if only a single tier is used.