Angry Cat with glowing eyes

Originally from Lyl3 - https://www.thingiverse.com/lyl3/designs
I've jokingly put a flexible LED panel behind the eys of this 3D Print and relised it could be more than just a silhuette. So here's what it came out.
I've printed everything at 0.3mm height and the only party with supports is the button switch.

Material: PLA
Height: 0.3mm (Preferibly 0.2mm)
Infill: 20%
Set Top and Bottom Walls to be a bit thicker to avoid warping waves as seen on my Print.

I've used some cosplay LED panels found on Aliexpress.

LED (Usually has a battery casing included): https://www.aliexpress.com/w/wholesale-Cosplay-Led-Eyes-Flexible-Bendable.html?spm=a2g0o.detail.search.0
BATTERY(In case it's not included: https://www.aliexpress.com/w/wholesale-3V-LED-battery-CR2032-case.html?spm=a2g0o.productlist.search.0

The LED Panel dimensions are: 27.5mm76.5mm, thickness 2mm-2.2mm, (effective luminous size 27.5mm69.5mm)
The CR2032 casing is the single battery one, NOT the dual battery!

IMPORTANT NOTE: You may need to shorten the wires from the battery to the LED panel as they come in very long. So, soldering is necessary.
Also, if you look there are 3 screws but they are not really necessary, you should be able to snap the cover in.

Hope you enjoy :D