International Scout II Body (SCX24)

This is a modified version of the Instructables Scout model found here: https://www.instructables.com/RC-Scout-II-3D-Printed-From-Scratch/

They have much more to it at the link I've pasted in here, such as an interior and exterior details. The model I've uploaded has been modified to allow more clearance for suspension articulation as well as cutouts for the battery and ESC/RX tray for an SCX24 (JLU length wheelbase). I've also added some mirrors I prefer, and a gas cap as separate pieces. You'll need to size everything to your liking or use case. For reference, I've listed the sizes that I printed them at and they all work together.

• Body/Hood/Canopy: 65.34% (note that this is not in mm, it's a percentage of what it will load at.)
• Gas Cap: 5.75mm diameter
• Side Mirror: 12.36mm (from bottom of mirror base to outer edge of mirror): so if you stood it on it's end for printing, it would stand 12.36mm tall.)
• Front Bumper: 92mm long (end-to-end)
• Magnet Mount (Front): Should be printed at 40.3mm from end to end (both versions are meant to be printed at this size and have cutouts for 8x3mm magnets (meaning the magnets have an 8mm diameter).
• Note, the version with the posts will be a lot stronger and less prone to breakage if printed on it's side with the posts horizontal.
• Magnet Mount (Rear): 43mm Wide (meant for 8x3mm magnets). It does have screw holes that should match the stock JLU rear hinge.