Retroid Pocket 5 Snap On-Grip (v2)

This is an updated version of my original design.

I have made a few improvements based on feedback.

1. The original was prone to slipping that would cause rubbing on the case. This is addressed via a couple of studs that align with the screw holes of the case. This keeps the grip firmly locked in place.
2. There was a request to create a version with a stand that would raise the triggers off the table. This version makes the device level while sitting on a table.
3. I have filled in the hole at the bottom of the grip.

Please refer to the attached images for advice on how to orient and add supports for this print.

To print the left grip, simply mirror the STL in the slicer of your choice.

Please remix this to your heart's content! It took a lot of iterations to get this to fit well and feel good in the hand, so tips are welcome!