L298N - CASE / COVER - SLIM

L298N - MOTOR DRIVER - H-BRIDGE - VOLTAGE REGULATOR - CASE / COVER / MOUNT

SUPPORT IS REQUIRED ON CAP!

There are a lot of clones and variations, hope this will fit on yours...

CLIP-INs might break during removal of the PCB... Due to not enough layer area of the dimensional requirement. After print; little post-process of cleaning the CLIP-INs center displacement with a UTILITY KNIFE. My advice would be to cut slow, steady and straight to prevent it breaking. As shown on front left it broke for the same reason. Depending on your printers/filaments and your slicer settings, your Z-Layer Adhesion might differ, thus resulting the CLIP-INs breaking for other reasons.

CLIP-IN PCB mounting and 3.6mm diameter holes for mounting the case to elsewhere.
PCB mount and CAP has diametrically aligned and identical mounting holes.

I printed my PCB mount with 2 colors just for user preferences no other purposes. It was a simple manual filament changing process since the eSun "Fire Engine Red" was almost finished, so no multi-color printing.

If requested in comments, a NON-CLIP-IN version, with mounting M3 hole version for the PCB can be tweaked and added in this thread.

PS: i also wanted them capacitors inside the cover but trust me it gets bulky for the terminal connectors, and some PCBs may have longer caps on it i donno :)