3D Pen Mini Spool Mount | SCRIB3D P1

Hardware neaded:
1 x M5x40mm screw
1 x M5 lock nut
2 x Ball Bearing 625 2RS 5x16x5

Installation of spool mount

1. Install the M5 lock nut into spool mount body
2. Screw in the M5x40mm screw into the spool mount body
   (the m5 locknut acts as the precision shim for the bearing in the spool to ride against)
3. Install the spool mount to your 3D pen with a twist motion and lock it down with the TPU strap (or rubber band if you don't have TPU).

Putting your mini master spool together.

1. Install the bearings in the spool bodies
2. Add the spool hub (optionable -- i did not install it and it works fine without)
3. Feed a few mm of your filament into one of the 3 holes in spool 2
4. Screw spool 1 and spool 2 together
5. Start winding your mini masterspool to load it up with filament
6. When done loading filament - mount your spool then lock the spool down with the spool lock
7. Turn on the 3D pen and preheat then load the fillament