Boss WL 60 Transmitter Strap Case/Holder

Case for the Boss WL60 transmitter. Works with 5cm wide shoulder straps. I included the f3d file for editing to other strap sizes.

It's a very snug fit for the transmitter, if you want it to have more room, you should scale it up by 1mm. I'd you're using thicker straps, make sure to adjust the width of the case to accommodate the strap. Currently, it has 1,5mm room for the strap.

This is a four part design, front and back halves should be glued together but can also work without it, however putting it back together after a battery change can be fiddly.

If you glue front and back together, you can also choose to glue on the top and not use the bottom piece because then the transmitter is held on place by the cable (if you use an angled plug) and friction.

Thickness is 1,6mm so the walls become solid if you print it with 4 perimeter lines at a line width of 0,4mm