Mercedes Benz CLK 500 iPhone Holder

Phone Holder for iPhone 13 Max Pro in an OtterBox Defender case.

Clips/slides onto to the car near the gear shift. Gluing the base to the clip and gluing the ball joint rod to the holster is recommended, but not 100% necessary. (Gluing the holster to the rod is 'more necessary.')

Print Notes:

The only item of note is related to the ball joint rod. There is a good of amount of force applied to this, so printing this piece (or at least the entirety of the narrow section at near 100% infill) is strongly recommended. I printed mine at 90% with 4 walls + alternating 5th wall.

Here is the link to the Tinkercad project. This could easily be adjusted to fit other phones and cases by adjusting the holster size, You do, however need to leave the hole at the bottom of the holster the same size so it connects to the ball joint rod.

https://www.tinkercad.com/things/cJ0tbsE7tDN-iphone-12-otterbox-mercedes-clk-500-phone-holder

I remixed two other designs as part of this.

Clip to connect to the car by riodoro1: https://www.thingiverse.com/thing:4663582
Ball joint by robertd33: https://www.thingiverse.com/thing:5429153