Dishwasher Clean/Dirty (low profile)

I really liked arustoni's Dishwasher Clean/Dirty design, but it's quite deep, so it can be hard to read the inset letters from above. One remix deals with that by angling it up, but then it sticks out and gets bumped by people walking past.

This is a flattened version of the design with some of the tolerances slightly tightened. It's about 5mm deep total, not counting the knob, and reduces each piece to about the flattest printable design for a 0.4mm nozzle with magnets and a color change. I also increased the magnet hole to being sized for a 12x3mm magnet; if you have 8x3 or 10x3 magnets, you can still glue them in, there will just be a bit of extra space around them.

Edited to add: To get high contrast letters, change the filament to a contrasting color around layer 4, or whenever the bottom of the letters is printed. Or print the whole thing in a pale color and fill in the indented letters with a sharpie, who's to judge?