WS Goggles X Mounting Bracket For X²-AIR 5.8 MK II Antenna

Bracket for Goggles X and these antennas:

https://www.truerc.ca/shop/5-8ghz-2/receiver-long-range/x%C2%B2-air-5-8-mk-ii-2

I used a heat gun to adjust the clips and get the antennas to sit right in them without snapping the PLA. You only get about 15 degree uptilt with these so keep that in mind. They bolt in using m2.5 bolts into the heat sink inserts under the LED plates.. My goggles did not come with the heat set inserts so I had to install my own. (Thanks for nothing Caddx)

I built the clip in F360 and integrated it into the remix file in tinkercad. I would have loved to integrate the old LED strips but I didn't think it was worth the effort.

I used tree supports in Cura, nothing special.