yes i got banned for this from 3D Printing Parts Group on FB.
You can also follow me on youtube.com/id10tgarage.
Comment away with your suggestions
***NOTE, this is still a work in progress, i am testing as i upload it for fitment. Use at your own risk
This can be sized to your desire, just don't do a uniform scale. Sit it on the bottom, and scale it up****
Window Mounted Swamp Cooler, Removable Hat for easy maintenance, add Ice to one side to keep it extra cool
8/28/2025:
- v4 Models - fixes thin areas and also adjust the Hat for a more snug fit
- Added 11mm Model, This is for window frames with a large cap on them
8/21/2025:
- Thin Walls currently on models in Vent and Window Attachment area. I will need to fix this, but still good test subject.
8/20/2025:
- Added a Cone for the skinny Cooler. Its meant to be glued to the rear to give it a more cone shape. 100% Cosmentic, mostly hollow
8/19/2025: Angle Mount - Very Much in TEST
Designed for strain relief on the top of the window
- Added Bottom Mount and W-mount versions of the design.
- Print the bottom mount nut side to the bed (1/4 x20) and a pause before the 1st layer that covers the nut. Insert your nut, then resume print..
- Requires 1/4" 20 Threaded Rod
- Bottom Mount Requires a M4 screw on Suction Cup for the Back. This goes on the glass
https://www.amazon.com/AccEncyc-Suction-Sucker-Without-Bathroom/dp/B0BWM24F3G)
- For already printed version i made a bolt on mount to go with the bottom mount
Added Truck Swamp Cooler
- This adds a little less the a 1/4" Tab at the top for Flat Glass Vehicles, That have a full frame around the window. This should stick into the window track at the stop to give a little extra strength
8/18/2025:
- Swamp Cooler required a bigger gap for window fit, and it was too tight again the drop rail. So i have adjusted this (Swamp Cooler Short Thin V3, Swamp Cooler Thin V3)
8/18/2025:
- Added Skinny Swamp Cooler and Hat. This is a 6" Tube version and also set to 250mm height for smaller printers. Design is scalable to preferred height, just make sure you on scale the height
- Updated All Hats, Short and Thin Hats had too much wiggle room, Wanted a firm fit, so new hats are only .02mm bigger then the tube (V3)
8/17/25:
- Added a thinner version of the Hat with bigger honey comb grille that designed to pop out more :)
- Added a shorter Hat (65mm vs 80mm)
8/16/25:
- Added Thin Version - Thinned the walls from 20mm to around 10mm....
jranger615
