Triumph Spitfire and GT6 door handle card trim

The model has been revised to better match the original part. Sorry for any inconvenience.
Thanks to user zerozeroniner on the Triumph Experience forum for pointing out the errors.

If you enjoy my 3dmodels then please consider buying me a cup of coffee at my Paypal tip page: https://www.paypal.com/donate/?hosted_button_id=ZRLFSSPLF5S4Y

Be sure to check out all my other designs at: https://www.thingiverse.com/bugeye59/designs

Triumph Spitfire and GT6 door handle card trim
Dean Hedin September 2025

This trim piece surrounds the interior door handle as shown in the photo of original. The large flange area attaches to the rear of the door card. Originally this was stapled but it is probably best to use an adhesive today.

If you alter material covering thickness on your doo card you can readily scale that part in Z in your slicer as required.

As discussed here:
https://www.triumphexp.com/forum/spitfire-and-gt6-forum.8/looking-of-info-on-a-part-i-discovered-on.2086620/

Print in ASA or ABS. No supports are required and the part prints in about 20 minutes on my Artillery X4 Pro.