Anti Pop filter for cheap U87 clone

If you have one of those cheap AliExpress U87 (that sound great for the price by the way) and you want some nice and wide anti pop filter, this model is for you !
Make shure the shock mount is the model shown on the picture
Tip: if you're about to buy one of those mics, go for the 34mm diaphragm model (the 26mm sounds thinner)

The dimensions are calculated so the mesh is 15cm from the mic's diaphragm

You'll also need some nylon stockings (worn or not, depends on your tastes)

• Print the parts
• Stretch a piece of stocking as much as you can above the frame
• Force fit the inner ring through the tissue (it should lock it in place)
• If everything is secured, cut the excess around the frame
• put the frame in the support (on the flat surface side)
• Hang the whole thing on the mic's shock mount

The tolerances are very tight, so if you can't fit the inner ring in the frame, scale it down to 99,9% or 99,8%

Print settings:

• Whatever filament you want (PLA works great)
• 3 upper and lower layers
• 3 walls
• 15% gyroid infill