Simple USB relocation for K1 Max CFS upgrade

This moves the USB to anywhere on the back of the printer that you want within the hexagonal impressions. A small dab of glue holds it in place. The USB extension i used is linked below. Ensure you get the up angled 1M setup. 1M is long enough to reach anywhere on the back of the printer. Just run the ribbon cable under the printer with some double sided tape(optional). Run the ribbon through the rear mount and attach it to the board and then push the USB board into the mount. On the front, you will connect the ribbon cable to the board and push it into the cutout and slide it up. The rear mount is a snug fit and the front is slightly loose.

https://a.co/d/aP95Ufl