Bulma Bunny Suit 1/6 TPU Articulated Action Figure

Fully articulated action figure of Bulma (Bunny Suit) from Dragon Ball

ONLY WORKS WITH TPU FILAMENT, 95A

I designed everything myself

1/6 scale, about 10.75 inches from bottom of the feet to top of the head, should scale good with Hot Toys and other 1/6 scale action figures

It might be possible to scale to 1/12 if reduced to 50%, however there are small pieces which may be tricky to print small

Comes with:
1 happy expression head sculpt
1 angry expression head sculpt
1 dragon radar hand accessory
1 set of pointing hands
1 set of fist hands
1 set of open hands

21 different files to print

Similar articulation to modern action figure lines like S.H. Figuarts and Marvel Legends

You most likely need auto generated supports

It is important that you set perimeters to 6, and use 60 degree overhang threshold in supports

Use 0.2mm layer height for everything

Around 20 or more points of articulation

Settings I use:

Layer height: 0.2
Perimeters: 6
Fill pattern: Honeycomb
Perimeter speed: 20
Infill speed: 30
Travel speed: 80
Support pattern: rectilinear
Support overhang threshold: 60 degrees
Filament diameter: 1.75
Extruder temperature: 230
Bed temperature: 50
Maximum fan speed: 65