Source one Street League Twist

Since the trend has been to make your street league as small as you can to get that center of mass closer to the center. I figured I would make one. well since I have lots of the source one dead cat arms and they are already legal for street league I figured i would design one around them. well this is what I came up with.
main plates are cut out of .125 steel. there is one center part to hold the arms in position I print that out of PLA. there is two small spacers that go between the plates on the outside of two of the arms, I also print those out of PLA. everything else is printed out of TPU. there is a canopy for the OG DJI camera, one for the O4 lite camera, one for O4 with the TPU Flywoo 155* O3 conversion, and one for a 19mm nebula pro/analog.
the skirt is designed to have a xt60 directly in it. but it does make the build a little tricky. you basically have to solder the xt60 on after the skirt is installed. but you can just make the power leads long and hang the xt60 out of the back. then if you slit the skirt you can slip the skirt on and off.