Honeywell TurboForce Fan HT-900 Pivoting Wall Mount

I wanted to be able to change the pivot/spin direction of my Honeywell Turboforce HT-900 fan after it was mount on the wall. Between this spin and the normal tilt of the original fan, I can point the airflow in almost any direction.

I printed most items in PETG for additional strength over PLA. The detents were printed in PLA, as it worked better for the little springs - PETG was too stiff.

Follow the pictures for assembly order. I used a small bolt/nut with washers through the middle of the three main pieces to hold it all together before mounting. I also used crazy glue / CA between the arms and the round spinbase piece. Mount to the wall with your favorite screws and anchors, as needed.

This was partially remixed from a design on Printables.
https://www.printables.com/model/737906-camera-clamp-stand-for-honeywell-turboforce-ventil

Differences of the remix compared to the original:
I only used the arms of the original model, removing the Go-Pro mount. I also merged the two halves of the arms since my printer can handle 310x310 volume. (The assembled arms measure 168mm (L) x 266mm (W) when flat on the bed.)

Many thanks to the original designer for the arms shape!