Higuruma's Gavel

After Higuruma's introduction episode I wanted his gavel for myself. The manga version of the gavel is extremely inconsistent, so I opted to design this model based off of the small snippets shown in the anime.

The model is four pieces in total: the handle, middle of the head, and the two sides of the head. The handle and middle of the head are both threaded and securely fit together without the need for glue. I would suggest printing the handle standing up with the threaded end at the top. You might be able to print it without supports, but I cannot confirm if that will work because I printed mine with supports enabled. The middle section of the head should be printed with one of its flat edges on the build plate, and with supports enabled for inside the threaded hole. The sides of the head are identical, so just print two of the same file. The sides will need to be glued onto the middle section, but they should fit onto it pretty snuggly with no movement while the glue dries.

I have adjusted the thread clearances since it was an extremely tight fit when I printed mine. I haven't tested out the new sizes, so if there are any issues please leave a comment.

I have not gotten around to painting my gavel, but I will upload finished pictures when I have.

From the suggestion of Beatsabernerd I have made a version that you can insert a debit or credit card into(hopefully I haven't tested it personally) so that you can bang the gavel down for tap to pay. Just make sure that all the card slots line up when putting the gavel together.