Gachiakuta Enjin's Umbreaker

All of the parts blades and sharp bits to create Enjin's Umbreaker in Gachiakuta. I sized it for and used the 48" SoulRain umbrella: https://www.amazon.com/dp/B0BZGSQ93M

Note: The blades are quite heavy relative to this umbrella, even with low infill. This makes for a great display piece or photo prop, but is not as good for carrying around or frequently opening and closing. The blades will wobble side-to-side while not open, so the stabilizer parts are necessary if you plan to use it while closed.

The blades are designed to glue onto the tips of the umbrella (I used Wood Weld 2 part epoxy), and sew through the fabric around the umbrella frame at the top. I reinforced the sew points on the umbrella with adhesive nylon patches: https://www.amazon.com/dp/B0FGCNRZ1M

Parts:

• blade whole: The whole blade, to cut for your printer as needed
• umbreaker tip: blunt spear end of the umbreaker
• blade part 1/2/3: pre-cut parts, pre-drilled with holes for 2.5mm rods
• blade tip: Cap to cover the sewing hole
• Paint reference 1/2/3: I used these to measure the silver/black border when painting
• Stabilizer 1/2: Useful to carry the umbreaker around (I recommend printing with TPU so the stabilizers are flexible and don't scratch the paint)

Paint Colors:

• Rustoleum Black Primer
• Rustoleum 2x Black
• Rustoleum 2x Aluminum
• Rustoleum High Performance Enamel Safety Yellow
• Soho Urban Artist Lamp Black + Mineral Spirits Wash
• Rustoleum Clear Gloss Enamel

See our Helldivers shovel videos on Instagram or Youtube for a short painting tutorial; I used the same painting techniques here as well.