XT60 Housing - Remix

Remix (slotted only) with the same external dimentions.
Parts to be connected using M3 x 8mm screw (M3 x 10 is too long) and M3 hex nut.

I do not know if XT60 connectors I have at home are genuine or not and what are the differences between them %-)
However, they fit into original connector (that I remixed from) with minor issues (too hard to put wire and a small gap between parts as not enough width).
So I believe if you can use original model, my model will work for you as well.

Changes:

• Added "stop" that holds connector in place (no need to glue it);
• External grips;
• Hex hole for nut;
• Additional inset for better positioning;
• More room for cables;
• Top/bottom walls' width extended from 0.7mm to 0.8mm (that is better for printing with 0.2mm layer height);
• XT60 connector's room extended from 8.04 to 8.2mm (XT60 width by spec 8mm);
• STEP file published.

Should be printed "grip sides on table" without supports using layer height 0.2mm and line width 0.43-0.5mm.

May the electric power be with you.