Simple Pully v0.1

A simple little pulley that I used to route my VR cables but could be used for numerous other purposes. Though if you intend it to do heavier lifting I recommend printing this at an angle with tree supports. The one I have printed here uses black Creality PETG. When importing into Orca-Slicer, if that is what your using, make sure to click yes to re-scaling or it will make it minuscule. (blender issue I haven't figured out how to fix, probably using the wrong unit.-.) Magnetic jelly doughnut not included.

Assembly:

It's pretty simple, first set the gimbal onto the male paddle. If your using glue as your fusing agent apply it to the flats on the male and the socets of the female paddel, then press firmly down on the female paddle until glue is cured. THE GIMBLE MUST BE INSTALLED BEFORE CONNECTING THE PADDLES, IT DOESN'T POP IN.

(if i would have made my base tolerances a little tighter that 1 mm (in all directions) for the connectors you wouldn't have to use glue at all. >.<", but with the super lose tolerance, you could probably print this in PLA and not have it shatter.)
Protected under CC-BY-SA 4.0 and I encourage remixing this model with your own improvements!