Pulley cover for Electric Skateboard

Direct replacement for Electric Bubblegum skateboard pulley cover. Not sure if it will fit on anything else.

General Print settings to get you started settings assume ABS plastuc

1. ONLY Print using High-temp high impact plastic, ABS or stronger. PLA does not work, it will melt.
2. Layer Height .20mm 5 outer layers
3. Infill 60% Hexigon
4. Print Speed 60mm/s
5. Temp 225c extruder 115c bed
6. Supports set to 75degree overhang threshold.
7. Always print on a glass bed using acetone slurry that is 95% acetone 5% abs filament by volume.

If you need any special pieces made or would like to buy any of my parts pre-printed or electric skateboard electronics please email me at [email protected]
.