AR drone 2.0 cross bar support/fix

Broke my cross bar and tried epoxy and some other things before making a quick fix on the printer, worked like a charm!
have crashed it plenty more and haven't been able to break it again.

its a little tight inside, used flat top 20mm m3 screws and lock nuts on the top, 5mm piece on top, 3mm piece on bottom. using two 3mm pieces would work fine tho.

will probably end up replacing the cross bar anyways since my break was pretty bad, but when i do i'll slim the design down a bit and put it in to prevent it from happening again.

.. Ended up dropping it out of the sky from about the same distance that broke it the first time and broke one of the legs off completely.

turned the whole center hub into a abs glue patty, let dry for 2-3 days and fly's, but still should replace it.

will make a better support b4 install when i can get another one.