May 5, 2013
Description
This is a snap-together chamshell housing for an open-source sip-and-puff interface I'm working on called openSip+Puff.
The housing is comprised of two halves that fit together using mating ledges that are offset by about 0.2mm.
It was created in OpenSCAD and is fully parametric, so if you need to adjust the fit (or anything else for that matter) just grab the .scad file and have at it!
The OpenSCAD script relies on the following libraries from MCAD:
Read more about the development process for this housing on my blog at: http://jason-webb.info/2013/05/snap-together-3d-printable-clamshell-housing-for-opensippuff/
License:
Creative Commons - Attribution - Non-Commercial - Share Alike
7,289
jasonwebb
