Meet the MK XIII Micro Quad frame! If you are looking for a brushed FPV frame to race inside and outside this is the frame of your dreams!

BOM (ORDER THESE PARTS TO MAKE ONE)~~~~~~~~~~~~~~~~~~~~~

Frame with motor mounts Weighs 10.8 grams
100mm diagonal X 70mm across motor spacing fits parrot props
Stiff enough to keep out nasty oscillations that play tricks on flight controller
(UPDATED) FPV camera now has better protection from nasty crashes and has a special slotted mount to securely hold FPV camera in place.
Micro Losi connector hard mounted to frame to keep wires out of props
(UPDATED) Motor wires are routed through a channel on the underside of each arm. This keep wires from getting damaged or snagged, while also making them easy to remove and instal without having to remove other components.
Frame arms support brushed motors from the bottom to prevent the shaft pushing the back plate off

(UPDATED) Integrated flight controller standoffs are now bigger and make it easier to mount the flight controller.
(Updated) larger diameter antenna passages allow for easy install in arms 1 & 2. Keeps Rx antenna safe and out of the way.
Designed to hold 8.5X20 brushed motors
Easy to print, requires no supports

(You can print this frame out of any material you want)

(MUST BE NINJAFLEX)

0.2mm layer height
225C first layer 220C rest of print
12mm/s print speed
No Support
100% infill
0.4mm Nozzle
0.28mm bead width (This is low because otherwise, the thin walls of the motor mount will not print)